Motorola WiNG 5.5 Reference Manual page 127

RF Mode
Channel
Transmit Power
6. If required, select a radio configuration and select the
7. The Radio Settings tab displays by default.
8. Define the following radio configuration parameters from within the
Description
Admin Status
Displays whether each listed radio is operating in the 802.11a/n or 802.11b/g/n radio
band. If the radio is a dedicated sensor, it will be listed as a sensor to define the radio as
not providing typical WLAN support. If the radio is a client-bridge, it will be listed as a
client bridge and does not provide typical WLAN support. The radio band is set from
within the Radio Settings tab.
Lists the channel setting for the radio. Smart is the default setting. If set to Smart, the
access point scans non-overlapping channels listening for beacons from other access
points. After the channels are scanned, it selects the channel with the fewest access
points. In the case of multiple access points on the same channel, it will select the
channel with the lowest average power level.
Lists the transmit power for each radio. The column displays smart if set for dynamic
Smart RF support.
Edit
Figure 5-24 Access Point Radio - Radio Settings tab
Provide or edit a description (1 - 64 characters) for the radio that helps differentiate it from
others with similar configurations.
Either select the Disabled or Enabled radio button to define this radio's current status
within the network. When defined as Enabled, the access point is operational and
available for client support.
Device Configuration 5 - 41
button to modify the radio configuration.
Properties field: