Rate Limiting - Planet FGSW-4840S User Manual

3.5.4 Rate Limiting

This page configures the rate limiting on each port. Ingress limit and egress limit can be configured independently. The
screen in Figure 3-13 appears.
Object
Port
Trunk
Ingress Limiting
Ingress Bandwidth
Egress Limiting
Egress Bandwidth
All port
If storm control is enabled on a port, the ingress rate limiting is not available on this
Note
:
port.100M port could not set the bandwidth value as 100M or greater.
Figure 3-13 Rate limiting screen
Description
The Switch port number.
If the port is a Trunk member, it indicates which Trunk it belongs to. Trunk members do
not support rate limiting.
Enable or disable the ingress rate limiting.
Value of the ingress bandwidth.
Enable or disable the egress rate limiting.
Value of the egress bandwidth.
By operating on this field expediently, you can set the values of all ports in the
corresponding field.
User's Manual of FGSW-4840S
14