Configuration; Web Configuration; Login The Switch - Planet FGSW-4840S User Manual

48-port 10/100mbps + 4g web smart ethernet switch

Hide thumbs Also See for FGSW-4840S:

Table of Contents

Unlike the unmanaged switch (Dumb switch), FGSW-4840S performs series smart functions that make the Switch operate

more effectively. This Chapter will describe the common usage of the Switch's Smart Configuration.

. The FGSW-4840S Web Smart Ethernet Switch provide Web interface for Switch smart function configuration. The

FGSW-4840S can be configured through the Web Browser. A network administrator can manage and monitor the

FGSW-4840S from the local LAN. This section indicates how to configure the Switch to enable its smart function. The

smart functions are shown as below:

◆ System Setting

◆ Port Setting

◆ Network Setting

◆ VLAN Setting

◆ Port Trunking

◆ Priority Setting

◆ Port Mirroring

◆ Virtual Cable Test

Before you start configure the FGSW-4840S, please note the FGSW-4840S is configured through an Ethernet connection,

make sure the manager PC must be set on same the IP subnet address. For example, the default IP address of the

FGSW-4840S is 192.168.0.100, then the manager PC should be set at 192.168.0.x (where x is a number between 1 and

except 100

254,

), and the default subnet mask is 255.255.255.0. Use Internet Explorer 5.0 or above Web browser. Enter

IP address http://192.168.0.100 (the factory-default IP address) to access the Web interface.

When the following login screen appears, please enter the default user name and password "admin" to enter the main

screen of FGSW-4840S. The login screen in Figure 3-1 appears.

3. CONFIGURATION

Figure 3-1 Login screen

User's Manual of FGSW-4840S

Table of Contents