Installing The Camera/Lens; Installing The Camera/Lens Mounting Tray - Bosch UPH series Operation Manual

High-Speed Positioning System
(HSPS)
4

Installing the Camera/Lens

This chapter outlines the procedures needed to install the camera/lens inside the UPH
housing.
Caution!
Installation must be made by qualified personnel and conform to ANSI/NFPA 70 (the National
!
Electrical Code
and all applicable local codes. Bosch Security Systems, Inc. accepts no liability for any
damages or losses caused by incorrect or improper installation.
Note: For models that already have the camera/lens installed, go to Installing the High Speed
Positioning System, page 20.
Notice!
This product must only be used with a UL-marked camera, rated 6-12 VDC with a maximum
power consumption of 5 W and a flammability class V-0 and Product Category NWGQ2,8.
4.1

Installing the Camera/Lens Mounting Tray

For some models of the High Speed Positioning System, the customer is responsible for
installing the camera and lenses.
To install the camera, follow these steps:
1.
Figure 4.1: Loosen Screws and Open Lid of Housing
2.
3.
Bosch Security Systems, Inc.
(NEC)), Canadian Electrical Code, Part I (also called CE Code or CSA C22.1),
®
Open the housing by loosening the captive screws on the side and swivel the upper body
until it is completely open (do not remove screws completely).
Remove the camera/lens mounting tray from the packing box.
Install the camera/lens mounting tray attached in the correct position inside the housing
at the location shown below.
Operation Manual
Installing the Camera/Lens | en
2013.11 | 5.2 | F.01U.291.981
15