Table of Contents
Advertisement
AUTODOME IP starlight 5100i (In-ceiling)
7
Installing an In-ceiling Camera in a Suspended Ceiling
7.1
Tools Required
–
–
7.2
Installation Requirements
–
7.3
Preparing the Suspension Ceiling for Installation
You must use the VGA-IC-SP In-ceiling Support Kit to install the camera In-ceiling housing into
a suspended or drop ceiling. This kit requires a separate purchase.
1.
2.
3.
4.
5.
4
4
4
Bosch Security Systems
Appropriate screwdriver (Phillips head)
Appropriate tool for cutting a hole in drywall or ceiling tile (if applicable)
The ceiling thickness ranges from 10 - 40 mm.
Choose the desired location to mount the camera.
Remove an adjacent ceiling tile.
Loosen the four (4) securing screws, located in the corners of the Bracket Assembly,
enough to hold the suspension bars but still allowing adjustment during installation.
Place the Bracket Assembly over the ceiling tile, which is used to mount the camera.
Snap the Bar Clips of the bracket to the ceiling rails.
Use the bracket Base Plate as a template or cut a hole-sized hole in the center of the
ceiling tile with a drywall utility saw or jig saw.
Tighten the four (4) securing screws to the Bracket Assembly.
Secure the Bracket Assembly to an overhead securing point with a safety wire.
Installing an In-ceiling Camera in a Suspended Ceiling | en
Installation Manual
15
2020-10 | 0.1 |
Advertisement
Table of Contents
