Kenwood KRC-235 Nstruction Manual page 19

Cassette receiver
Hide thumbs Also See for KRC-235:
Table of Contents

Advertisement

Tuner source
? Radio reception
is poor.
ti
The car antenna is not extended.
=
Pull the antenna out all the way.
_ ~.~~ ~~-
..-..
_. _~..
/
The antenna control wire is not connected.
w Connect the wire correctly, referrlng to the section on
<Connecting
Wires to Terminals>.
Disc source
? "AVin"
is displayed
without
achieving
External
disc control
mode.
d
O-N switch is set to "0" side.
e
Set the switch to "N" side.
4
Unsupported
disc changer is connected.
ti
Connect the supported disc changer. (page 31
? The specified
disc does not play, but another
one plays instead.
/
The specified CD is quite dirty.
=
Clean the CD.
~~~
_~-.
--
.._ -_.---
~
d
The CD is upside-down.
=
Load the CD with the labeled side up. ~~
__--..
-..
~~
.---...
d
The disc IS loaded in a different
siot from that specified.
=
Eject the disc magazine and check the number for the specified
disc
(/
The disc is severely scratched.
m Try another disc instead.
? The specified
track will not play.
ti
Random play or magazine random play has been selected.
c* Turn off random play or magazine random play.
? Track repeat, disc repeat, track scan, random
play, and magazine
random
play start by themselves.
4
The setting is not canceled.
e
The settings for these functions
remain on until the setting to off
or the disc ejected, even if the power is turned off or the source
? Cannot play CD-R or CD-RW.
s/ Finalization processing is not being conducted for CD-R/CD-RW.
a+ Conduct flnalizatlon
processing with CD recorder
/A
non-compatible
CD changer is being used to play the CD-R/CD-RW
u* Use a CD changer compatible
with CD-R/CD-RW to play.
?Track Search can't be done.
d
For the albums first or last song
~1 For each album, Track Search can't be done in the backward
direction for the first song or in the forward direction for the last
If the following
situations,
consult
your nearest service
center:
l
Even though the drsc changer is connected, the Disc Changer source is
not ON, with "AVin" showing in the display during the Changer Mode
l
Even though no device (CA-CIAX)
IS
connected,
the Auxiliary input is
entered when switching
modes.
a*
-19-

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Krc-225

Table of Contents