Kenwood KRC-235 Nstruction Manual page 16

n Installation
Firewall or metal support
\
similar utensil and
attach It in place
Self-tapping screw
Metal mounting strap
(commercially available) (commercially avatlable)
Q
:::. Make sure that the unit IS installed securely in place. If the unrt is
- unstable, It may malfunctron (for example, the sound may skip)
W installing in Japanese-Made Cars
1
Refer to the section "Removing the hard rubber frame" (page 17)
and then remove the hard rubber frame.
2 Align the holes in the unit (two locations on each side) with the
vehicle mounting bracket and secure the unit with the accessory
screws.
T: Toyota cars
N. Nrssan cars
i
Accessory3 for Nrssan car
Accessory@ . ..for Toyota car
A !
l
During installatron, do not use any screws except for those provided.
The use of different screws might resutt in damage to the main unit
l
Damage may occur if a screwdriver or similar tool
is
used with
excessive force during the installations
B Screwing the Faceplate on the Unit
If you want to fasten the
Accessory<&,
faceplate to the main unit so
that it does not fall off,
screw in the provided screw
(04
X 16 mm) In the hole
shown below.
A !
Never insert the taptite screw (04 x 16 mm) in any other screw hole
than the one specified If you screw it in another hole, it will contact
and may cause damage to the mechan$cal parts inside the unrt.
-16-