Kenwood KRC-235 Nstruction Manual page 17

n Removing the hard rubber frame
n Removing the Unit
1 Engage the catch pins on the removal tool and remove the two
locks on the lower level.
Lower the frame and pull it forward as shown in the figure.
1
Refer to the section "Removing the hard rubber frame" and then
remove the hard rubber frame.
2 Remove the screw (M4 x 8) on the back panel.
3 Insert the two removal tools deeply into the slots on each side,
as shown.
Screw (M4X81
(commercially
available)
sory@
val tool
Removal tool
2 When the lower level is removed, remove the upper two
locations.
4 Lower the removal tool
toward the bottom, and pull
out the unit halfway while
pressing towards the inside.
A !
Be careful to avoid injury from
the catch pins on the removal
tool
Q
;;I' The frame can be removed from the top side In the same manner
5
Pull the unit ail the way out
with your hands, being
careful not to drop it.
'a+.
- 17-