Spraying Technique - Central Pneumatic 47016 67181 Owner's Manual & Safety Instructions

Delayed or inadequate cleaning will permanently clog the Spray Gun.
Latex paint hardens quickly and permanently inside Spray Gun.

Spraying Technique

IMpORTANT: Proper spraying technique
is ESSENTIAL to achieve good results.
1. First, prepare the Spray Gun
according to the instructions under
Spray Gun Setup Adjustment on page 10.
2. Keep the Spray Gun upright and
at a right angle to the workpiece -
See Figure G and Figure I.
Correct Gun Angle
Move your arm, not just your wrist.
Point gun directly towards the surface and
maintain an even, steady distance and speed.
Incorrect
Gun
Angle
Figure G: Spray Gun Angle - top view
Correct Gun Angle
Figure I: Spray Gun Angle - side view
3. Using two hands, one to steady the Cup
and the other to operate the Spray Gun,
aim Nozzle at the workpiece.
Item 47016 67181
NOTICE
Clean the Spray Gun IMMEDIATELY after EVERY use.
Do not pivot your wrist
or wave the gun like a
fan towards the wall.
Incorrect Gun Angle
For technical questions, please call 1-888-866-5797.
CAUTION: DO NOT STOp WHEN SpRAYING.
Spraying materials will start to set and dry
as soon as they come in contact with the air.
They will cause a permanent clog if not cleared
immediately. If discontinuing spraying for more
than half an hour, turn off the air supply, disconnect
Cup from Gun Body and thoroughly rinse Cup
and Gun Body with fresh, clean water.
4. Pull Trigger slowly and move Spray Gun in
parallel strokes to the workpiece. Keep the
distance from the workpiece at about 6" to 9",
depending on the flow adjustment and the paint.
5. To avoid paint build up, start moving the Spray Gun
before squeezing the Trigger.
When finished with the stroke, release the Trigger
while still moving the Spray Gun - see Figure J.
Doing this will produce a smoother finish.
Do not stop moving the Spray Gun while spraying.
If the Spray Gun stops even briefly while spraying
the paint will build up and run down the workpiece.
Begin Squeeze
Stroke Trigger
Figure J: paint Stroke Triggering - top view
Note: The stroke speed, the Fluid Knob
adjustment, and the distance from the workpiece,
will determine how much paint is being applied.
Apply two thin coats rather than one thick coat.
CAUTION! Air hose fittings may get hot.
Allow fittings to cool before disconnecting,
or wear gloves to prevent burns.
6. To prevent accidents, release trigger, detach
air supply, safely discharge any residual air
pressure, and again release trigger after use.
Clean Spray Gun thoroughly immediately
7.
after EVERY use, according to
instructions on the following pages.
Release End
Trigger Stroke
Page 11