LG LSC27921 series Owner's Manual page 11

Removing the left (freezer) door with water line
connection.
• Pull up the water feed tube while pressing area
(Figure 1) as shown in the figure below.
• NOTE: If a tube end is deformed or abraded, trim the
part away. Disconnecting the tube under the door
causes about 0.13 gallons (0.5 liters) water to
flow out. Put a large
prevent water from draining
Figure 1
(2)
(1)
(4)
(5)
(6)
(7)
Type 1
1. Open the door. Remove the top hinge cover screw (1).
2. Use a flat blade screwdriver to pry back the hooks
(not shown) on the cabinet underside of the cover (2).
Lift up the cover.
3. Disconnect all the wire harnesses (3).
4. Remove the grounding screw (4).
5. Rotate hinge lever (5) counterclockwise . Lift the top
hinge (6) free of the hinge lever latch (7).
NOTE: Regardless of hinge lever type, removal process is
the same.
When lifting the hinge free of the latch,
be careful that the door does not fall forward.
6. Lift the door from the lower hinge pin
pull the water lines through the lower hinge pin.
7. Place the door, inside facing up, on a nonscratching
surface.
REFRIGERATOR INSTALLATION REFRIGERATOR INSTALLATION
container at end of tube to
onto the floor.
(5)
(3)
(7)
(6)
Rivet
Type 2
being careful to
Reinstalling the right (Refrigerator) door
(1)
Type 1
1. Place the door onto the lower hinge pin.
2. Fit top hinge (4) over hinge lever latch (5) into
place. Rotate lever (3) counterclockwise to secure
hinge.
NOTE: Regardless of hinge lever type, removal process is
the same.
3. Hook tab on switch side of corner under edge of wire
opening in cabinet top. Position cover (2) into place.
Insert and tighten cover screw (1).
Reinstalling the left (Freezer) door
(2)
(1)
(4)
(5)
(6)
(7)
Type 1
1. Feed the water tubes through the lower hinge pin and
place the door onto the lower hinge pin.
2. Fit top hinge (6) over hinge lever latch (7) and into
place. Rotate lever (5) clockwise to secure hinge.
NOTE: Regardless of hinge lever type, removal process is
the same.
3. Install the grounding screw (4) and connect all the
wire harnesses (3).
4. Hook tab on door switch side of cover (2) under edge
of wire opening in cabinet top. Position cover into
place. Insert and tighten cover screw (1).
5. Reconnect the water tubes by inserting the tubes into
the connectors.
11
(2)
(3)
(3)
(4)
(5)
(4)
(5)
Type 2
(3)
(5)
(6)
Rivet
Type 2
Collet
Tube
Insert Line
Rivet
(7)