Estpair (Adding Pairs) - HP StorageWorks XP24000 User Manual

ESTPAIR (Adding Pairs)

Table 38 (page 97)
you create SIz pairs.
Table 38 ESTPAIR Command Parameters (Adding Pairs)
Parameter
DDNAME,
SYSNAME, or
UNITADDRESS
PRI
SEC
MODE
PACE
CRIT
MSGREQ
LSS
2
ONLINSEC
1 CU number or the parameter is valid only for the DKC emulation type 2105 or 2107.
2 When you do not specify the parameter, the result is same as when you specify NO for this parameter.
Figure 41 (page 98)
lists and describes the ESTPAIR command parameters that can be used when
Value
DDNAME = dname = JCL statement identifying
the volume.
SYSNAME = sysxxx = SYSNAME in the
ASSGN system control statement.
UNITADDRESS = ccuu = device number.
Primary volume (S-VOL): SSID, serial number,
and channel connection address.
You must set MSF00 instead of a serial number
to request the Add and Split operation. This
parameter is valid for MODE(COPY) or
MODE(NOCOPY) only.
You must set MAnn0 instead of a serial number
if you create SIz pairs in a CTG with ID nn.
Secondary volume (T-VOL): SSID, serial
number, and channel connection address.
COPY
NOCOPY
1
Other than 1
Not applicable.
YES
NO
Primary volume CU number, or secondary
1
volume CU number.
YES
NO
shows an example of the PPRCOPY ESTPAIR command.
Description
You should specify only one parameter of the
three parameters. The italic part on the left
means that it is the arbitrary name. For
example, dname means the arbitrary unique
name of the JCL statement which identifies the
volume.
If you set a parameter other than the
parameters on the left, the command will be
rejected.
When you perform ESTPAIR command on SIz,
no matter whether you specify COPY or
NOCOPY for the MODE parameter, the
storage system recognizes it as COPY mode.
Therefore, initial full-volume copy will be
performed.
Copy speed will be slow, except when the DKC
emulation type is 2105 or 2107. When the
DKC emulation type is 2105 or 2107, the
copy speed is always medium regardless what
you specify for the PACE parameter.
Copy speed will be medium.
SIz does not use this parameter. SIz ignores it.
If you specify this parameter when
MODE(RESYNC) is set, the command ends
abnormally by reporting CC = 12. Do not
specify this parameter when MODE(RESYNC)
is set.
Pair create operation will be performed
whether the T-VOL is online or not.
Pair create operation will not be performed if
the T-VOL is online.
Adding Pairs Using PPRC Commands 97