TRENDnet TEW-638APB Quick Installation Manual page 11

5. I followed the Quick Installation Guide and setup a new password. When I log
in to the browser configuration an access error message appears. What should I
do?
If the password was changed and you don't remember it, you need to reset the
TEW-638APB. To reset the TEW-638APB, power up the unit and wait 30 seconds
for the unit to boot up. Then take a pin or paper clip and press the reset button for
15 seconds, then let go. The reset button is located on the bottom of the
TEW-638APB. Please note that performing a reset on the TEW-638APB will erase
all settings applied and will revert back to default settings. The default user name
is admin and the default password is admin. When you log in to the browser
configuration for the first time, make sure to enter admin for user name. Do not
leave the user name field blank.
6. How do I configure AP Client mode on the TEW-638APB?
Please refer to the User Guide. The User Guide is on the provided CD-ROM.
If you still encounter problems or have any questions regarding the TEW-638APB,
please contact TRENDnet's Technical Support Department.
LED/Button Color
Green
PWR (Power) LED
N/A
Network Port
Green
Link/Act LEDs
N/A
Green
Wireless LED
N/A
Green
WPS LED
N/A
Power Switch
N/A
(EU Version only)
Reset Button N/A
WPS Button N/A
If you still encounter problems or have any questions regarding the TEW-638APB,
please contact TRENDnet's Technical Support Department.
Sequence
Definition
Solid Device is on
Off Device is off
LAN port connected at 10/20 Mbps or 100/200Mbps
Solid
(Half/Full Duplex)
LAN port data transmitting/receiving 10/20Mbps
Blinking
or 100/200Mbps (Half/Full Duplex)
Off LAN port is disconnected/No Ethernet Link
Blinking Wireless LAN is on or enabled/Wireless data transmission
Off Wireless LAN is off or disabled
Solid
WPS authentication process complete
Blinking
WPS authentication in process
Off WPS is not activated or disabled
N/A Turns on/off power to the TEW-638APB
N/A Hold 10 seconds to reset device to factory defaults.
N/A Hold 10 seconds to activate WPS
9