1. Before You Start Package Contents Ÿ TEW-638APB Ÿ Multi-Language Quick Installation Guide Ÿ CD-ROM (Utility and User's Guide) Ÿ Power Adapter (12V DC, 0.5A) Ÿ Network Cable (0.6m / 2ft.) System Requirements Ÿ Web Browser: Internet Explorer (6 or higher), Firefox 2.0 or higher, Opera, Chrome, Safari Ÿ...
Page 4
2. Hardware Installation Note: 1. Locate an optimum location for the Access Point. The best place for the Access Point is usually at the center of your wireless network. 2. Disable any anti-virus and firewall programs before starting hardware installation. For Windows Users 1.
Page 5
7. Connect the Power Adapter to the Access Point and then to a power outlet. Then click Next. 8. Select the TEW-638APB from the list and then click Configure. 9. Enter a password and then click Login. The default password is admin.
Page 6
10. Select Access Point and then click Next. Note: For AP Client setup, please refer to the User's Guide for step by step instructions. The User's Guide can be found on this product's CD-ROM. 11. Select Dynamic IP Address Configuration and then click Configure.
Page 7
14. Select the desired Wireless Mode and then click Next. 15. Select a Security Mode and then click Next. Note: 1. To protect your network from any unauthorized access it is recommended to enable wireless encryption. 2. The example below is for WPA2-PSK (AES) security. If you select WPA-PSK or WPA2-PSK, make sure your wireless adapters support WPA or WPA2.
Page 8
17. Click Save (optional). This saves your configuration settings in a file, which can be roloaded when needed. 18. Give the file a name, then click Save. 19. Click Configure to apply the settings. 20. Click Exit.
21. Click Yes to exit. 22. Connect the 2dBi detachable antennas to the TEW-638APB. Note: To connect a wireless computer to the TEW-638APB, please refer to the first question in the troubleshooting section. Your Installation is complete For detailed information regarding the TEW-638APB’s configuration and advanced settings, please refer to the Troubleshooting section, User's Guide on the Utility CD-ROM, or TRENDnet's website at http://www.trendnet.com.
Page 10
How do I setup WPS between the TEW-638APB and my wireless adapter? 1. Press on the WPS button on the front of the TEW-638APB for 10 seconds. 2. Refer to your wireless adapters for instructions on setting up WPS.
Page 11
If the password was changed and you don't remember it, you need to reset the TEW-638APB. To reset the TEW-638APB, power up the unit and wait 30 seconds for the unit to boot up. Then take a pin or paper clip and press the reset button for 15 seconds, then let go.