Brake Shoe Wear - Honda CG125 Fan Owner's Manual

58
(8)
(10)
(7)
Installation Notes
• To install the rear wheel, reverse the removal
procedure.
• Tighten the axle nut and stopper arm nut to
specified torque.
Axle nut torque:
88 N·m (9.0 kgf·m, 65 lbf·ft)
Brake stopper arm nut torque:
22 N·m (2.2 kgf·m, 16 lbf·ft)
• Adjust the brake (page 19) and drive chain (page 52).
• After installing the wheel, apply the brakes several
times, and check for free wheel rotation when
released.
If a torque wrench was not used for installation, see
your Honda dealer as soon as possible to verify proper
assembly. Improper assembly may lead to loss of
braking capacity.
A used cotter pin may not effectively secure the
fastener. Always replace the used cotter pin with
new one.
(7) Lock nuts
(8) Drive chain
adjusting nuts
(9) Rear axle nut
(10) Rear axle shaft
(9)

Brake Shoe Wear

(Refer to the Safety Precautions on page 39.)
The front and rear brakes are equipped with brake
wear indicators.
When the brake is applied, an arrow (1) attached to
the brake arm (2) moves toward a reference mark (3)
on the brake panel (4). If the arrow aligns with the
reference mark on full application of the brake, the
brake shoes must be replaced. See your Honda dealer
for this service.
When the brake service is necessary, see your Honda
dealer. Use only genuine Honda parts or its equivalent.
Front brake
(3)
(4)
(2)
Rear brake
(1)
(4)
(3)
Owner´s Manual
(1) Arrow
(2) Brake arm
(1)
(3) Reference mark
(4) Brake panel
(2)