Table of Contents
Advertisement
10
Electrical system
10.1
Electronics protection system
The vehicle drive electronics is fitted with an overload protection.
If the drive is severely overloaded over a long period (e.g. during steep climbs) and, above all, at
simultaneous high external temperatures, the electronic system can overheat. In this case, the
vehicle performance is gradually reduced until it comes to a standstill. The status display shows a
corresponding blink code (please refer to the instruction manual for your remote). If you switch the
drive electronics off and then on again, the error message is deleted and the electronics can be
switched on again. It can however take up to five minutes until the electronics has cooled down
enough for the drives to apply their full performance.
If the drive is blocked due to an insurmountable obstacle, for example a kerb or similar which is too
high, and the driver attempts to run the drive for more than 20 seconds against this obstacle, the
electronic system switches the drives off to avoid damage. The status display shows a
corresponding flash code (please refer to your remote instruction manual). If you switch the drive
electronics off and then on again, the error message is deleted and the electronics can be switched
on again.
NOTE
A defective main fuse may be replaced only after checking the entire electric system. An
Invacare® specialised dealer must perform the replacement. You can find information on the
fuse type in chapter "Technical specifications" starting on page 102.
67
Advertisement
Table of Contents
