Working On The Heating System; Instruction In Function And Operation; Checking The Condition Of The Heating System - Buderus Logano plus SB315 Operating Instructions Manual

Working on the heating system

2 Working on the heating system
ATTENTION
Only qualified personnel must carry out the
installation, the main fuel and flue gas
connections, the initial start-up, the
electrical connection as well as
maintenance or repair work. Only
registered Corgi and ACS may carry out
work on gas components.
2.1

Instruction in function and operation

The installation engineer should instruct the user in all
functions covering the safe operation of the heating
system and must hand over the relevant technical
documentation for safe keeping.
2.2 Checking the condition of the heating
system
NOTE FOR USERS
Please regularly check the water level in
your boiler. Arrange for water to be
replenished, if the water level is too low.
Never use boiler water for domestic use.
Open all radiator valves, shut-off valves and damper
valves in the heating system.
Vent the whole system at the air vent valves
provided.
Check, whether the cleanout covers and doors have
been closed.
Check the water level in the system and top up, if
necessary.
Check the system inlet pressure, on your expansion
vessell. If necessary notify your installer, who may
adjust your heating system to the correct operating
pressure.
We reserve the right to make any changes due to technical modifications.
Operating instructions Logano plus SB315 and Logano plus SB315 VM • Issue 04/2006
2
5