Prepare Pressure Washer For Storage - North Star 1572041 Owner's Manual

 Add fuel stabilizer to the gasoline (following
manufacturer's instructions)
Fuel stabilizer steps:
a. Ensure gas tank is full.
b. Add fuel stabilizer to fuel tank.
c. Run pressure washer with high
pressure hose at least 5 minutes after
adding stabilizer to allow it to enter the
fuel system.
d. Shut off engine
2. Lubricate cylinder and piston:
a. Disconnect spark plug wire and remove spark
plug
b. Add one teaspoon oil through spark plug hole
c. Place rag over spark plug hole and slowly pull
the recoil a few times to lubricate the
combustion chamber.
Replace spark plug, but do not reconnect the spark
plug wire.

Prepare Pressure Washer for Storage

Prepare the pressure washer for storage.
1. Make sure the engine start switch is OFF.
2. Disconnect the engine spark plug wire if you haven't
already done so.
3. Disconnect the high-pressure hose, garden hose,
and spray gun.
Move Pressure Washer to Storage Location
Let engine cool for 5 minutes before moving the
pressure washer to its storage location.
25