Congratulations on your purchase of the Your pressure washer is made of high quality components to ensure the top performance you demand. Take the time to read this entire manual so you better understand the machine, how to operate it, the maintenance required and the safety precautions. You will find the assembly, operating, maintenance and troubleshooting instructions included.
15. Never alter or modify the unit or its safety features. Be sure all components can handle the high pressure this unit generates. 16. Be sure all connections are secure before operating the unit. Do not over tighten pressure washer adjustments; excess pressure, irregular unloader operation and wear may occur.
Seek medical attention immediately if fluid penetrates skin. Do not treat as a simple cut. 19. Always release system pressure after shutting off the pressure washer by squeezing the wand trigger. Never leave the unit unattended with system still pressurized.
GROUND-FAULT-CIRCUIT-INTERRUPTER A GFCI is built into the plug of the pressure washer power supply cord. This GFCI provides additional protection from electrical shock. Use only the identical replacement parts that include GFCI protection when replacing the plug or power cord.
INSTALLATION INSTRUCTIONS If installing the 157394 indoors or in an enclosed area, observe the following guidelines: ANGER - Operate the unit on a level surface to ensure proper lubrification to the water pump. - Be certain the ambient temperature of the environment does not exceed 100°F. This ensures adequate air supply for the burner, - Do not expose the unit to rain, snow or freezing temperatures.
Fit the lance terminal end. To ensure you are in the high pressure mode, turn the nozzle holder to the right. Your 157394 is now ready to be used as a cold water pressure washer. Turn the ANGER unit on by pushing the pump switch on the control panel. Squeeze the trigger-gun to spray a high pressure stream and release the trigger to stop the stream.
Do not allow the unit to operate in the bypass mode (trigger not squeezed) for more than 3 minutes. Failure of pump packing may result The unit is now ready to be used as a hot water pressure washer. Squeeze the trigger-gun to spray a high pressure stream, and release the trigger to stop the stream.
Disconnect power cord and unit hoses. USING THE DETERGENT INJECTOR This feature is designed for use with mild detergents. North Star detergents are highly recommended for use with all North Star pressure washers. Prepare cleaning solution according to the detergent label directions.
Electrical cords and connections should not contact water. Always follow STOPPING THE PRESSURE WASHER instruction outlined on page 10 of this manual. Do not operate the unit in bypass mode (trigger not squeezed) for more than 10 minutes, this will cause premature failure of the pump packings.
TROUBLESHOOTING SYMPTOMS The water pump will not start The water pump will not enter in bypass The water pump does not reach maximum pressure Strong vibrations on the water pump The burner will not start Anormal noise of Diesel pump No detergent suction CAUSES The motor thermic protection is open...