Invacare TDX SC Operator And Maintenance Manual page 48

SECTION 6—SEAT - TDX SC ONLY
8. Remove prop rod from the clip located on the Formula CG frame and engage the prop
rod end into the front seat post.
9. Gently allow weight of seat assembly to be supported by the prop rod.
NOTE: Only leave the seat assembly in the UP/OPEN position while performing any necessary
procedures. Always lower the seat assembly to the DOWN/CLOSED position when not servicing
the wheelchair. Ensure the seat is locked in place before using.
Tilting the Seat Assembly Forward
1. Using one hand, firmly grasp the front edge of the seat assembly and lift until seat
assembly is no longer supported by the prop rod.
2. Disengage the prop rod from the front seat post and secure into clip.
3. Using both hands, slowly tilt the seat assembly FORWARD into the DOWN/CLOSED
position.
Ensure the two mounting screws, washers and locknuts are securely tightened and
the seat frame is locked in place before use - otherwise injury or damage may result.
4. Using the two mounting screws, washers and locknuts, secure the seat frame plate to
the two front seat posts.
FIGURE 6.2
TDX® SC TDX® Spree
WARNING
UP/OPEN
Position
DOWN/CLOSED
Position
- Tilting the Seat Assembly - Wheelchairs without Latch Bar Only
Mounting Screw
Seat Frame Plate
Washer and Locknut
Front Seat Post
NOTE: Seating
system not shown.
48
Part No 1149267