Handling Of The Fr-Arwe-1 Parameter Copy Unit; Handling Of The Fr-Puo1 E Parameter Unit - Mitsubishi Electric Freqrol-A100 Instruction Manual

1.4.3 Handling of the FR-ARWE-1 Parameter Copy Unit
Like the FR-PU02E-I, the FR-ARWE-1 parameter copy unit can be installed to the inverter (can also
be connected to the inverter by a cable) and allows operation to be performed, functions to be set,
and operating status to be monitored. (The [A] and [V] keys are different in function from those of
the FR-PU02E-I.)
The FR-ARWE-1 also allows the parameters of one inverter set per application to be read in batches
and easily copied to the other inverter.
- 1
When the FR-ARWE (ARWE-I) is used
to
copy parameters between the FR-A100 and FR- AlOOE series
inverters, the set values of Pr. 65 is as indicated below depending on the series of the
inverters and the
product version of the FR-ARWE
(ARWE-I).
The FR-A100 series do not have the function of Pr. 65. Hence, the old ARWE parameter copy unit
(product code H01) compatible with the FR-A100 series cannot recognize Pr. 65 and cannot copy it
properly. To copy it properly, use the ARWE-1 or new ARWE parameter copy unit (product code H02)
compatible with the FR-A100E series. (See page 186)
Pr. 65 'retry selection'
<FR-ARWE product version>
Differentiation
The type of the latest parameter copy unit is the FR-ARWE-I.
Also, the other parameter copy unit FR-ARWE has two versions.
The product code is given on the rating plate on the back of the parameter copy unit.
Old copy unit: Product code H01
New copy unit: Product code H02
Comblnatlon
Parameter
NumberlName
4
1.4.4 Handling of the FR-PUO1 E Parameter Unit
COPY
Source
ARWE.1 and
new ARWE
(Product code H02)
( p r o ~ ; ~ t ~ ~ H O 1 )
I
For the use of the FR-PUO1E parame
COPY
Destlnatlon
2
t
The FR-PUO1 E parameter unit can be used by connection
to the inverter by a cable (option). It cannot be installed
directly to the inverter.
3
A100E
O
A100
COPY
Source
COPY
Source
Set values are not copied.
Set values are not copied,
?r unit, note the following points.
COPY
Source
COPY
Destlnatlon
COPY
Destlnatlon
With the power on, you can-
When the FR-PUOIE parameter unit is being used, reset the
not use the the FR-PUO1E
inverter once in either of the following methods, with the parame-
and FR-PUOSE-1 parameter
ter unit connected by the cable.
units by changing them alter-
*Switch the power off once, and in more than 0.1 seconds,
nately. switch it on again.
*After connecting the reset terminal RES and SD for more than
0.1 seconds, disconnect them.
COPY
Destlnatlon
A100 E AtOOE A t 0 0 O A t 0 0
Set values at the copy
destination
do
not change,
Set values at the
COPY
destination do not change.
Note: The inverter recognizes the type of the parameter unit at
the time of reset cancel or power-on and does not com-
municate with any parameter unit other than the one
recognized.
A100E O A100E
Set values at the copy
source are written to the
copy destination.
Set values at the
COPY
destination do not change.
Set values are not copied.
Set values are copied'