Installing The Microprocessor Module - Dell Inspiron 1100 Service Manual
Hide thumbs
Also See for Inspiron 1100:
- Owner's manual (164 pages) ,
- System information manual (110 pages) ,
- Service manual (75 pages)
Table of Contents
Advertisement
Documentation
1 ZIF-socket cam
screw
2 ZIF socket
3 microprocessor
module
4 pin-1 corner of
microprocessor
5 triangle on system
board
7.
Use a microprocessor extraction tool to remove the microprocessor module.
Installing the Microprocessor Module
NOTICE:
Ensure that the cam lock is in the fully open position before seating the
microprocessor module. Seating the microprocessor module properly in the ZIF
socket does not require force.
NOTICE:
A microprocessor module that is not properly seated can result in an
intermittent connection or permanent damage to the microprocessor and ZIF
socket.
1.
Align the pin-1 corner of the microprocessor module so that it points to the triangle
on the system board, and insert the microprocessor module into the ZIF socket.
When the microprocessor module is correctly seated, all four corners are aligned
at the same height. If one or more corners of the module are higher than the
others, the module is not seated correctly.
NOTICE:
Hold the microprocessor down while turning the cam screw to prevent
intermittent contact between the cam screw and microprocessor.
2.
Tighten the ZIF socket by turning the cam screw clockwise to secure the
microprocessor module to the system board.
3.
Wipe the thermal grease off of the microprocessor thermal-cooling assembly with a
clean paper towel.
4.
Squeeze all of the contents of the thermal grease packet (provided with the kit) on
to the microprocessor thermal-cooling assembly.
5.
Replace the
6.
For the Inspiron 5150, replace the
2 of 3
microprocessor thermal-cooling
palm rest
http://support.dell.com/support/edocs/systems/ins5100/en/sm/cpu.htm...
assembly.
and then replace the
display
panel.
2008-03-11 10:28
Advertisement
Table of Contents
