Carriage Frame Assembly - Oki ML390 Service Manual

3.2.16 Carriage Frame Assembly

· Perform these procedures:
· Detach the head clamp (1).
· Use a flat-blade screwdriver to release the tabs of the ribbon protector (2).
· Remove the ribbon protector.
· Push the carriage shaft clamp (3) in the direction of arrow A.
· Lift the carriage shaft (4) at position B.
· Remove the carriage shaft from the guide hole by pulling at position C.
· Remove the carriage shaft, with the carriage frame (5).
· Slide the carriage frame off the carriage shaft.
NOTES:
Installation
Perform the printhead gap adjustment after installing this assembly.
Handbook for details
Cleaning
When cleaning, refer to Section 3.4 of this Service Handbook
Lubrication
When lubricating, refer to Section 3.5 of this Service Handbook
P/N 51109401 Shaft: Carriage Both 90 RSPL A B C
P/N 51109402 Shaft: Carriage Both 91 RSPL A B C
P/N 50702901 Clamp: Head All RSPL A B C
P/N 53490401 Frame: Carriage (Assembly) All RSPL A B C
P/N 53056201 Protector: Ribbon All RSPL A B C
3.2.01 , 3.2.03
.
B.2.09
Service Guide ML390/391
Chapter 3 Maintenance & Disassembly
, 3.2.04 , 3.2.14 , 3.2.15
Refer to Section 3.3 of this Service
.
B.2.04 , B.2.06
B.2.04 , B.2.06
B.2.09
B.2.09
.
.
Page: 59