Step 4: Configuring The Bridge; Configuring The Bridge Through The Web Interface; Configuring The Bridge Through The Command Line; Interface - Efficient Networks SpeedStream 5600 Series Installation Manual

Step 4: Configuring the Bridge

Once your 5600 unit is functioning in bridge mode, you can configure the
Bridge through either the Web Interface or the Command Line Interface:

Configuring the Bridge through the Web Interface

Creating a Virtual Circuit using RFC 1483 Encapsulation:
Start your web browser
1
Enter the bridge's IP address:
2
The browser displays the bridge's management interface.
3
On the main page, click on
4
Enter the
5
provider. If your provider has not given you a VPI and VCI, click the
set defaults
Select the desired RFC 1483 multiplexing method (LLC or VCMUX).
6
Select
7 Max
Click on the
8
Defaults
When the response appears at the bottom of the screen, it will include
9
a link that says "
to reboot the bridge.
yes
Select
10
new configuration. Refer to "Web Interface" on page 25 for more
information on configuring the bridge via the web interface.

Configuring the Bridge through the Command Line

Interface

The command line interface is designed for advanced users. Refer to
"Command Line Interface" on page 26 for more information about the
command line. Detailed instructions for using the command line interface
Efficient Networks
and numbers provided by your Internet service
VPI VCI
button and skip to step 9.
as the rate.
Create VC
to return to the default configuration.
REBOOT REQUIRED
after the Ethernet (
Refresh
10.0.0.1
Simple Setup
button to set new parameters or select
". Click on that link and choose
enet
.
) light turns green to see the
Bridge Configuration
Set
21