Table of Contents
Advertisement
When the HyperTerminal window appears, you must press the [
6
key five times to get the "Command->" prompt.
Type
7
set bridge enable
You will be prompted to reboot the unit. Enter the
8
the prompt and press
You will then be prompted to confirm your request. Type
9
and press
The unit will reboot and come back up in bridge mode.
10
Step 2: Assign an IP Address to your PC
Manually Assigning an IP Address
IP address range 10.0.0.2 to 10.0.0.254
•
Subnet Mask: 255.0.0.0
•
Default gateway: 10.0.0.1
•
Step 3: Setting the Password
The bridge has no password protection as configured from the factory. As
soon as you log into the bridge, you should set the password. This can be
done from the web interface by clicking on the "
from the command line interface using the
Password protection can be disabled again by entering the current
password and a blank for the new password. If the password is forgotten,
the unit can be set to the factory default state from the serial port during
the boot process. Refer to "Restoring the Factory Default Configuration"
on page 30 for more information on this procedure.
NOTE:
accidental or malicious defaulting of your configuration.
20
Bridge Configuration
Enter
. Any existing Telnet sessions will be closed.
Enter
It is wise to restrict physical access to the bridge to prevent the
and press
Enter
.
set password
.
reboot
Set Password"
command.
Efficient Networks
]
Enter
command at
for "yes"
y
link or
Advertisement
Table of Contents
