Configuring The Router Through The Command Line; Interface - Efficient Networks SpeedStream 5600 Series Installation Manual

Select
11
new configuration. Refer to "Web Interface" on page 25 for more
information on configuring the router via the web interface.

Configuring the Router through the Command Line

Interface

The command line interface is designed for advanced users. Refer to
"Command Line Interface" on page 26 for more information about the
command line. Detailed instructions for using the command line interface
are available on the web interface. Click "Advance Setup" and then "5600
Series Command Line Interface User's Guide".
Method 1: Via Telnet
Start your Telnet client. If you are using Windows on a PC, select
1
>
Start
type
telnet 10.0.0.1
The Telnet client connects to the router and displays a command line
2
prompt.
Enter the desired configuration commands and parameters when
3
prompted.
The router can also be reset to the factory default configuration from the
command line interface using the
Method 2: Via the Serial Port
Select
1
HyperTerminal
Enter a name in the
2
In the
3 Connect To
to the router and click
Enter the following port settings:
4
Bits per second
Data bits
Parity
16 Router Configuration
after the Ethernet (
Refresh
and enter
Run
.
>
Start Programs
Connection Description
window, select the serial port you have connected
enet
. If you are on a UNIX system,
telnet 10.0.0.1
default all
>
Accessories
.
OK
38400
8
None
) light turns green to see the
command.
>
HyperTerminal
window and click
Efficient Networks
>
OK