Advertisement
Fitting the LCD.
BEFORE FITTING ENSURE THAT LCD IS FITTED WITH FLEXY SUPPORT LABEL.
BEFORE FITTING ENSURE THAT LCD IS FITTED WITH FLEXY SUPPORT LABEL.
OPEN THE ZIFF CONNECTOR BY PULLING OUT THE WHITE LOCKING WEDGE.
TAKE THE LCD WITH THE GOLD PADS ON THE FLEXY FACING UP AND INSERT THE
FLEXY INTO THE ZIF CONNECTOR.
WHEN THE FLEXY IS FULLY INSERTED AND THE TOP EDGE OF THE PADS ARE
PARALLEL TO THE CONNECTOR BODY, PUSH THE LOCKING WEDGE FULLY IN
(THIS MAY REQUIRE PRESSURE APPLIED AT THE CENTRE OF THE CONNECTOR AS
WELL AS THE TWO OUTER LUGS).
LOCATION PIPS
ZIFF CONNECTOR
FOLD THE LCD OVER SO THAT THE LOCATION PIPS ON THE LCD ENGAGE IN THE
LOCATION HOLES IN THE BOARD, AND THE RETAINING CLIPS ENGAGE OVER THE
EDGES OF THE BOARD.
TAKE CARE WHEN PUSHING DOWN ON THE LCD TO ENGAGE THE RETAINING CLIPS,
PUSH ON THE PLASTIC EDGES NOT THE LCD GLASS.
PUSH THE LOCKING WEDGE FULLY IN.
LOCATION CLIPS
ON BOTH SIDES
A PIECE OF 'MYLAR '
TAPE IS TO BE FITTED
ACROSS THE ZIFF
CONNECTOR AND FLEXI
TO ADD SUPPORT.
IT MUST STICK TO: -
THE LCD FLEXI,
THE LOCKING WEDGES
ON EITHER SIDE OF THE
CONNECTOR AND
THE PCB EITHER SIDE OF
THE CONNECTOR.
Advertisement
