Wine Rack Removal/Installation; Wood Trim Finishing - U-Line Echelon 2275DWRWS Wine Captain Installation Manual

4 Prepare Racks and Caddy
®
The U-Line Wine Captain
trimmed wine racks that are coated at the factory with a
clear vinyl sealer, which will adequately protect the wood
in normal usage. A final finish coat was not applied so
that the wood trim could be stained to match décor. The
trim on the racks may be coated with a final finish or
stained.
If neither of these treatments are to be included in this
installation, go on to 5 Adjust Drawers.
CAUTION
To prevent permanent damage to the inner liner of the
®
Wine Captain , the wine rack wood trim MUST be
removed from the unit for staining and/or finishing.
Allow stain/finish to dry thoroughly (at least 24 hours per
coat) in accordance with the stain/finish manufacturer's
instructions prior to re-installing the wood trim inside the
cabinet of the Wine Captain
the inner liner of the unit to have a permanent odor,
which is not covered by the warranty.

Wine Rack Removal/Installation

To remove a rack from the cabinet:
1. Grasp the end of the rack, and gently slide it out until
it stops.
2. Remove any bottles stored on the rack.
Figure 5
3. Press the left rack release lever (see Figure 5) down,
and at the same time, lift the corresponding right rack
release lever up, and pull the rack out until it is free of
the tracks and the cabinet.
IMPORTANT
Do not remove the track side rails from the cabinet.
02/2007
2275DWRWS/2275DWRWOL —
Drawer Model Wine Captain
is equipped with wood-
®
. Failure to do so may cause
ULIN_0155a_A
®
To insert a rack in the cabinet:
1. Align the left and right rack channels with the tracks
in the cabinet, and ensuring an even track
engagement on both sides, gently push the rack into
the cabinet until it stops.
2. Before reloading the rack, ensure proper operation of
the travel stops in the left and right track rails by
pulling the rack out gently until it completely stops.

Wood Trim Finishing

The U-Line Wine Captain
trimmed wine racks that are coated at the factory with a
clear vinyl sealer, which will adequately protect the wood
in normal usage. A final finish coat was not applied so
that the wood trim could be stained to match décor. The
trim on the racks may be coated with a final finish or
stained.
To prevent permanent damage to the inner liner
of your unit, the wood trim MUST be removed
from the unit for staining and/or finishing. Allow
stain/finish to dry thoroughly (at least 24 hours
per coat) in accordance with the product
manufacturer's instructions prior to
reinstallation. Failure to do so may cause the
inner liner of the unit to have a permanent odor,
which is not covered by the warranty.
If staining the trim is desired, it must be done before the
application of any type of final finish. Review the
following staining/final finish and final finish-only
guidelines when staining/ and or sealing the wood to
ensure proper adhesion and durability of the finish.
Note: Glass in door is tinted. Stain may look darker when
door is closed.
Staining and final finish application:
1. Remove all screws securing wood trim to interior
components, and remove the trim from the cabinet
interior.
To remove the top drawer display wood trim:
5
3
Figure 6
2. Remove the two screws (Figure 6, 1), securing trim to
wine rack assembly (Figure 6, 2).
7
®
is equipped with wood-
WARNING
1
4
ULIN_0831_A
www.U-LineService.com