U-Line Echelon 2275DWRWS Wine Captain Installation Manual page 3

General Precautions
Use this appliance for its intended purpose only and
follow these general precautions along with those listed
throughout this guide:
WARNING
SHOCK HAZARD — Electrical Grounding Required.
• Keep the unit unplugged throughout installation
except during testing.
• Never remove the round grounding prong from
the plug and never use a two-prong grounding
adapter.
• Never use an extension cord to connect power to
the unit.
• Always keep your working area dry.
WARNING
The Anti-Tip Kit must be installed on this unit
before it is used. Never use the drawers as steps
or as a shelf to support more than the drawers'
contents. Serious personal injury could occur.
CAUTION
• Use care when moving and handling the unit. Use
gloves to prevent personal injury from sharp edges.
• Do not lift the unit by the drawer handle.
• Do not install the unit behind closed doors or in any
way that would obstruct airflow to the front grille,
which may cause the unit to malfunction.
02/2007
2275DWRWS/2275DWRWOL —
Drawer Model Wine Captain
2 Inspect and Plan
You have received a carton containing your 2275DWRW
Drawer Model Wine Captain
containing a Use and Care Guide, a Product
Registration Card and Anti-Tip Kit. Complete and mail
the Product Registration Card or register online at
www.U-LineService.com. Once your unit is installed, keep
the Use and Care Guide and this Installation Guide in a
safe place for future reference.
Your unit is either an Overlay or Stainless Steel. Overlay
units have drawers with black glass fronts that are
designed to accept a 3/4" wood overlay frame, and a
black vinyl-clad cabinet.
Stainless Steel units have drawers with stainless steel
framed fronts, sculpted stainless steel handles and a black
vinyl-clad cabinet.
All units come with maple trim wine racks and caddy that
can be finished or stained. Please carefully follow the
directions that apply to your unit and your intended
design.
Tools/Materials Required
• Screwdrivers - slotted and Phillips head
• Sandpaper; low odor, water clean up, quick drying
finish; tack cloth and, if desired, water-based wood
stain and synthetic foam brush
• 3/4-inch overlay frame material, cutting tools, drill and
bits (2275DWRWOL units)
Inspection
Unwrap and inspect the unit on a flat, level surface
capable of supporting its entire weight.
Removing Protective Coating
Stainless Steel Models:
When inspecting/installing a Stainless Steel unit, the
protective coating covering the drawer fronts must be
removed. Start at a corner of the drawers and pull back
the protective coating to remove it from the drawer
fronts.
After all the protective coating has been removed from
the drawers, clean all Stainless Steel surfaces with Claire
Stainless Steel Polish and Cleaner or comparable product
or a mild detergent and warm water solution and soft
cloth. Do NOT use abrasive cleaning agents.
Note: If cleaning with mild detergent and warm water
solution and soft cloth, the unit MUST be treated with
Claire Stainless Steel Polish and Cleaner or comparable
product to prevent discoloration.
Clean all glass surfaces with a non-chlorine glass cleaner.
3
®
®
with a package inside
www.U-LineService.com