Wood Overlay - U-Line Echelon 2275DWRWS Wine Captain Installation Manual

Minor Adjustment:
Note: The mounting holes on the slide are slightly larger
than the screws' diameter.
Screws Should
Be Loose
Level the Slide
Figure 14
1. Loosen one slide's mounting screws.
2. Level the slide.
3. Retighten the screws (see Figure 14).
4. Repeat procedure for the other slide.
Severe Adjustment:
Note: The slides have extra mounting holes that may be
used.
Mark and Drill New
Mounting Holes
Level the Slide
Figure 15
1. Loosen one slide's rear mounting screws.
2. Remove the slide's front mounting screws.
3. Reposition the slide so it is level.
4. Mark new front drilling holes using a different set of
mounting holes on the slide (see Figure 15).
5. Drill the new holes with a #30 drill bit.
6. Remount the slide.
7. Repeat procedure for the other slide.
02/2007
2275DWRWS/2275DWRWOL —
Drawer Model Wine Captain
ULIN_0001g_A
ULIN_0001h_A
11
®

Wood Overlay

Frame Preparation
An overlay frame covers the drawer front to give a built-
in appearance. Appropriate hardware and a copy of these
instructions will be included in the unit.
IMPORTANT
The thickness of the overlay frame must be 3/4". The
drawer frame must not weigh more than 10 lbs.
Create two frames to the dimensions shown in Figure 16.
23-13/16"
2-3/4" Typ
4 Sides
Figure 16
1. Make sure unit is unplugged from the electrical outlet.
Note: If cabinet handles are installed, make sure the
mounting screw heads are below (countersunk) the back
surface of the overlay.
2. Starting with the TOP drawer, open drawer fully.
You should have already prepared the overlay panel
and have the cabinet handles installed.
3/4"
14-13/16"
ULIN_0620_A
www.U-LineService.com