Installing The Tv On/Off Detector - Bose Lifestyle DVD Installation Manual

Installing the 71/on/off detector
The TV on/off detector senses whether your TV is on or off and enables the media center to
automatically switch your TV on and off as needed. If this device is not installed, you will need
to turn your TV on and off using the remote control that came with your TV.
• Attach the TV on/off detector to the back of your TV using the mounting strip included with
your new system (Figure 16).
• Plug the connector on the end of the cord into the TV SENSOR jack on the back of the
media center.
Note: This device will work correctly only after your system is programmed to operate your
brand of TV. See "Programming your remote control to control your TV" in your operating
guide.
Note: If you have a projection TV, mount this device on the lower back portion of the enclo-
sure opposite the connector panel.
Note: This device will not work with LCD and plasma TVs.
Figure 16
TV on/off detector installed
on your TV
TV on/off detector
Back of TV
TV SENSOR jack
Media center rear panel
18 August 14, 2001 AM 259777 Rev.O0 PDF