Toshiba RAS-M10NKV-E Service Manual page 50

No. Part name
4
Heat exchanger
1) Remove the front panel, electrical part
2) Remove the pipe holder at the rear side of
3) Remove the 2 screws on the heat
4) Remove the 2 screws on the heat
5
Cross flow fan 1) Remove the front panel, electrical part,
2) Remove the 2 screws on the band motor
3) Loosen the set screw of the cross flow fan
Notice
To assemble cross flow fan and fan motor to
the unit, please turn the fan motor unit the
center of its terminal meets the lowest point
of band motor (R) (point A).
Fix the cross flow fan with the set screw at
the position where the gap between the back
body and the right surface of the cross flow
fan is 4 mm.
6
Base bearing 1) Remove the front panel, electrical part,
2) Remove the 2 screws fixing the base
3) Remove the bearing from the base
Procedures
and the horizontal louver following
procedure 3.
main unit.
exchanger at the base bearing.
exchanger at the 2 fixed plates (upper and
lower) from the back body, and then pull
out the upper side of the heat exchanger
slowly.
horizontal louver and the heat exchanger
following procedure 4.
(L) and remove the 2 screws on the band
motor (R) and then remove the cross flow
fan.
then separate the fan and the fan motor.
horizontal louver, heat exchanger and the
cross flow fan following procedure 5.
bearing.
bearing. If the housing protrudes from the
base bearing, put the housing in position
and attach the bearing to the base
bearing.
– 49 –
FILE NO. SVM-05019
Remarks
2 Pipe holder
3 2-Screws
4 2-Screws
2 2-Screws (R)
2 2-Screws (L)
5 mm
3 Set screws
Middle of the fan motor terminal
2 2-Screws