Enterasys - HP 800 User Manual

9. Re-enter the console password.
10. Enter the password with which to enter enable mode.
11. Re-enter the enable mode password.
12. Enter the networks (using CIDR notation) that this device is in direct
control over in the Network list text field. This is only necessary if the
device does not send its IP address with its supplicant request.
13. Enter the Cisco port mask in the text field. This specifies which characters
within the endpoint identifier returned by the Cisco device contain the
bank and port information of the endpoint. All offsets start at 0, so a mask
of 2/34 indicates character 3 for the bank and characters 4 and 5 for the
port. If the Cisco device were to return 50210 for an endpoint, a port mask
of 2/34 would indicate that the endpoint is on bank 2 and port 10 (2/10),
where 210 are the third, fourth and fifth bytes in the identifier.
14. Enter the Reconnect idle time. This is the amount of time in milliseconds
that a telnet/SSH console can remain idle or unused before it is reset.
15. Select the Show scripts plus symbol to show the following scripts:
Initialization script – The expect script used to log into the console and
•
enter enable mode.
Re-authentication script – The expect script used to perform endpoint
•
re-authentication.
• Exit script – The expect script used to exit the console.
16. Click ok.
TIP:
Click revert to defaults to restore the default settings.

Enterasys

To add an Enterasys device:
NAC 800 home window>>System configuration>>Quarantining>>802.1X
Quarantine method radio button>>Add an 802.1X device
System Configuration
Quarantining
3-65