Yamaha 2010 FX Nytro FX10X Service Manual page 706

To the auxiliary DC
(FX10M53Z/FX10M53SZ/
FX10M62SZ)
Throttle cable
Radiator fan motor coupler
Make sure to insert the clamp
into the hole of the steering
gate.
Wire harness
Fuel injection system sub-wire
harness coupler
Speed sensor coupler
To the radiator fan motor
Fasten the speed sensor lead to
the frame rear cross member
with the plastic band.
Route the auxiliary DC jack lead
outside of the radiator fan motor
lead and fuel injection system
sub-wire harness and inner side
of the radiator
(FX10M53Z/FX10M53SZ/
FX10M62SZ)
Tighten the ground lead termi-
nal together with the left radiator
bracket.
Fasten the speed sensor lead
and fuel tank breather hose to
the frame rear cross member
with the plastic band, making
sure not to pinch the hose.
Fasten the speed sensor lead
and fuel tank breather hose to
the frame with a plastic locking
tie, and then cut off the excess
end of the tie.
Face the ends of the hose
clamp rearward.
Install the fuel tank breather
hose completely onto the hose
joint.
Fasten the corrugated tube of
the speed sensor lead with the
holders.
Speed sensor cover
Speed sensor
Fasten the wire harness, at the
portion just before the leads
split, to the frame rear cross
member with the plastic band.
Fasten the wire harness, oil
pressure switch sub-lead, and
crankshaft position sensor lead
to the frame rear cross member
with the plastic band.
jack
hose.
156
CABLE ROUTING
SPEC