Yamaha 2010 FX Nytro FX10X Service Manual page 592

STEERING
6. Install:
For FX10RTRZ/FX10RTRSZ
• Steering joint
• Steering joint holders
TIP
• Install the steering joint with the shallow cut-
out facing forward.
• Align the centerline of the steering joint with
the centerline of the steering column
shown in the illustration.
• The steering joint holders should be
installed with punch marks
ward.
NOTICE
First, tighten the bolts on the front side of
the steering joint holder, and then on the
rear side.
Steering joint holder bolt:
23 Nm (2.3 m•kgf, 17 ft•lbf)
7. Install:
• Handlebar
• Handlebar holders
• Steering joint (FX10M53Z/FX10M53SZ/
FX10M62SZ)
TIP
• The handlebar holders should be installed
with the punch marks
• Align the punch mark
with the upper surface of the lower handlebar
holder. (FX10Z/FX10XTZ)
• Align the punch mark
with the upper surface of the steering joint.
(FX10RTRZ/FX10RTRSZ/ FX10M53Z/
FX10M53SZ/FX10M62SZ)
42
CHAS
as
facing for-
facing forward.
on the handlebar
on the handlebar