Hardware Installation - D-Link DCS-6220 User Manual

DCS-660 User's Manual

Hardware Installation

1
Connect an Ethernet cable
Connect an Ethernet cable to the network cable connector located
on the DCS-6620's back panel and attach it to the network.
2
Attach the external power supply
Attach the external power supply to the DC power input connector
located on the DCS-6620's back panel labeled 12V and connect
the other end to your wall outlet.
Power LED
LED stands for Light-Emitting Diode.
The Power LED is positioned in the center of the PTZ Internet Camera base. As soon as the power adapter
is connected to the PTZ Internet Camera, the power and the activity LED will flash
times. The DCS-6620 is conducting a self-test. Upon passing the self-test, the
the green LED will start to blink to indicate a good connection to an Ethernet port.
connected to the camera via a crossover cable, the light may cycle on and off and your computer
may show an intermittent loss of connectivity. This is normal until you have configured your PTZ Internet
Camera. The absence of a blinking
Attaching the PTZ Internet Camera to the Camera Stand
The PTZ Internet Camera comes with a camera stand and a swivel ball screw
head that can be attached to the PTZ Internet Camera bottom socket cavity.
Attach the camera stand to the PTZ Internet Camera and station it for your
application. There is a hole located in the base of the camera stand allowing the
PTZ Internet Camera to be mounted to the ceiling, or any wall securely.
D-Link Systems, Inc.
green LED indicates no connection has been made.
Hardware Installation
red and green several
red LED will be solid and
If you are directly
9