Logs, Glowing Embers, Volcanic Stone Placement - Lennox Hearth Products Montebello LSM40MN-2 Care And Operation Instructions Manual

When satisfied that the appliance operates
properly, proceed to finish the installation. Leave
the control knob in "ON" position and turn the
remote switch "OFF."
air shutter
opening
Venturi
orifice
Burner
Venturi
Main Burner Factory air shutter
opening setting - inches (millimeter)
Model nat.Gas
LsM40-2 1/16 (1.59)
LsM45-2 1/16 (1.59)
Figure 5
Log placement
WarninG
Logs get very hot and will remain
hot up to one hour after gas
supply is turned off. Handle
only when logs are cool. turn
off all electricity to the appliance
before you install grate and logs,
if applicable.
WarninG
this appliance is not meant
to burn wood. any attempt to
do so could cause irreparable
damage to your appliance and
prove hazardous to your safety.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
8
the size and position of the log set was engineered to give your appli-
ance a safe, reliable and attractive flame pattern. any attempt to use
a different in the fireplace will void the Warranty and will result in
incomplete combustion, sooting, and poor flame quality.
Carefully position the ceramic fiber logs and twigs over the burner as shown in Figure 6 (LSM40-2)
or Figure 7 (LSM45-2) on this Page. refer to the detailed log placement instructions provided
in the ceraMic paneL and LoG pLaceMent Guide accompanying this document.
Proper twig placement is critical to prevent sooting. Twigs should be placed in the gaps between
the flame peaks and should be positioned so that at no time they impinge the flames. Placement
is the same for all colors and styles of logs.
Gas
Valve
propane Gas
9/2 (7.14)
9/2 (7.14)
Figure 6
Figure 7
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
WarninG
(Birch Logs Shown)
(Rustic Oak Logs Shown)
LSM40-2
LSM45-2