Install The Drain Hose; Gas Leakage Inspection; How To Connect Wiring To The Terminals - Haier AU282AHBEA Service Manual

(Fig. 15)
Indoor unit
Apply the indoor unit to the brackets.(Fig.16)

5. INSTALL THE DRAIN HOSE

Select whether the drain hose will be connected to the left or right side.(Fig.3)
Insert the drain hose into the drain pan, then secure the drain hose with a nylon fastener.(Fig.6)
Wrap the insulation (drain hose)around the drain hose connection.(Fig.7)
Be sure to arrange the drain hose correctly so that it is leveled lower than the drain hose connecting port of the
indoor unit.(Fig.8)
(Fig. 17)
Arrange the drain hose
lower than this portion
When drain hose is arranged backward. Secure the drain hose with the VT wire. (Fig. 18)
(Fig. 18)
Pass the drain hose through here

GAS LEAKAGE INSPECTION

After connecting the piping, check the joints for gas leakage with leakage detector.

HOW TO CONNECT WIRING TO THE TERMINALS

A. For solid core wiring (or F-cable)(Fig.19A)
(1) Cut the wire with a wire cutter or wire-cutting pliers, then strip the insulation to about 25mm of the exposed solid
wire.
(2) Using a screwdriver, remove the terminal screw(s) on the terminal board.
(3) Using pliers, bend the solid wire to form a loop suitable for the terminal screw.
(4) Shape the loop wire properly, place it on the terminal board and tighten securely with the terminal screw using
a screw driver.
Hex bolt
8 to 13mm
(Fig. 16)
Now, securely tighten the hex bolts in both sides.
Remove the hole cover.
Drain hose
OK
VT wire hole
For series 14,18,24
CAUTION
>a__WcU[S^ <[c >a`V[e[a`Wc
Bolt
Indoor unit
NO
Piping hole
Base (Bottom)
Intake grill
Cut the grill
-130-
Bracket