Installation Preparation; Tools And Materials Required; Remove The Packaging - Monogram ZV48T Installation Instructions Manual

TOOLS AND MATERIALS REQUIRED

(NOT SUPPLIED)
Duct tape
Pencil and tape measure
Spirit level
Pliers
Metal Snips

REMOVE THE PACKAGING

• Lift out the wooden crossmember, as well as the top
protective carton.
• Remove the protection moldings around the smaller
carton box.
• Remove the small box housing the motor.
• Lift the hood out of the box.
CAUTION
the outside edges of the inlet opening of the hood.
damage will occur!
49-80151-8

Installation Preparation

Wire cutter/
stripper
Safety glasses
Step ladder
Saber saw
or Sawsall
Lift the hood by grasping
Hammer
Key Hole Saw
Wire nuts
Flashlight
120V 60Hz. 15 or 20 Amp,
2-wire with ground. Properly
grounded branch circuit.
Wood
Mounting
Support
Motor
• Remove the shipping screws holding the wood
mounting piece to the back side of the hood.
Set aside the wood mounting piece and screws
for later installation. Do not discard.
• Remove the "V" shaped carton insert.
• Remove the parts package from the "V" shaped
cardboard insert.
• Remove the junction box cover and knockout.
• Install the strain relief onto the back or top of the hood.
• Remove all tape and packing material from the hood, duct
transition and motor.
Electric or battery operated
drill and 1/8", 3/8" bits
10" round
metal duct,
length to
suit installation.
blade screwdrivers
Strain relief for
junction cover.
Hood
Parts
Package
Shipping Carton
9