Advertisement
EASY PROGRAM MODE OVERVIEW (Using a LIBRA-DXK4RF Series Keypad)
ENTERING THE EASY KEYPAD PROGRAM MODE
1 Enter the Dealer Security Code (default = 456789) for a new panel or enter your custom Dealer Program Code if
programmed and press
2 Press NO ("
" or
X
q
NOTE: If you pass "
3 Press YES ("r" or
Use the following guide to answer the Easy Program Mode questions which will quickly allow you to create a custom
default program. Press
u
backwards,
to save and
ANSWERING A QUESTION IN THE EASY PROGRAM MODE
The Easy Program Mode the questions will be in the form of a 2-digit number flashing in the digital display.
Pressing
will set the cursor into the next field to answer the question.
w
Using this book as a guide, enter the appropriate data in response to each question and then press
If no additional programming is necessary for the question, press NEXT ("r" or
REVIEWING THE DATA ENTRY IN THE EASY PROGRAM MODE
The data entered in response to an Easy Program Mode question may be reviewed before saving.
• After entering the data before pressing
flashing in the display again.
• Pressing
will step through all the fields of the question for review and will then result in the 2 digit question
w
number flashing in the display again.
If the data is correct, press
If the data is not correct, press
Note: The contents of an Easy Program Mode question may be reviewed after the initial programming of the control,
with the exception of the questions which are marked (Appears for New Panel Only). These questions set up the
basic structure of the control panel program (Number of zones in an area, etc.) and cannot be viewed or altered once
set.
EXITING THE DEALER PROGRAM MODE
If in the Easy Program Mode, press
end all programming and resume normal keypad operation.
RESETTING THE CONTROL PANEL TO FACTORY DEFAULT
If necessary, the control panel can be returned to the factory default and be re-programmed from scratch.
• For the GEM-P816 and GEM-P1632, enter the Direct Address program mode, go to location 1198 and press
(
w1198
.
w
) repeatedly until function "
" you can scroll back by pressing
17
) to enter the Dealer Program Mode.
p
to set cursor, NEXT ("r" or
w
twice to exit the Easy Program Mode.
y
u
to save,
u
to save.
to set the cursor into the next field and again enter the appropriate data.
w
to enter the Direct Address Program Mode. Press
y
u)
" (Activate Program Mode) is displayed.
17
.
x
) to go forwards, PRIOR ("
p
may be pressed until the 2 digit question number appears
w
" or
X
u
to save.
) to go to the next question.
p
y
) to go
q
once again to
u.
7
Advertisement
