Advertisement
22
(Direct Entry)
24
(Direct Entry)
25
(Direct Entry)
26
(Direct Entry)
DATA ENTRY
CS RECEIVER 1 FORMAT
blank(•)
Ademco Slow, Silent Knight Slow
1
Sescoa, Vertex, DCI, Franklin Fast
2
3
Silent Knight Fast
4
Radionics, DCI, Franklin Slow
5
Universal High Speed
8
27
(Direct Entry)
Number of Keypads
Directly enter the total number of Keypads to be installed. Valid entries are from 01 to 07. Directly
enter the number of keypads, including leading zeros. Use number buttons
NOTE: Press
0
Central Station Receiver 1 Telephone Number
Using number buttons, enter telephone number of up to 16 digits including prefix letters, if necessary,
for receiver 1. Use number buttons
and
through
G1
Tone Detection = "E". Pressing
NEXT ("r" or
p
only be entered in Direct Address Programming. See CS Receiver Options.
Central Station Receiver 1 Account Number
Enter an account number of up to four digits. Use number buttons
9. NOTE: Press the
u
Press
to save. Press NEXT ("r" or
Account Numbers can only be entered in Direct Address Programming. See CS Reporting Options.
Central Station Receiver 1 Format
From the table below, enter the central station's receiver format. Use number buttons
. NOTE: Press the
9
through
G1
p
) to proceed.
Radionics Fast
Radionics BFSK
Enter User Codes (Press the (
Enter up to 64 User Codes with User Options for each code. Refer to the tables below for available
data entries for User Options.
Press
once to set cursor to the User Number and enter the desired User Number. Press
w
once again to set the cursor to the User Code. Use the number buttons
w
to enter a code from 3 to 6 digits. Enter up to 6 digits (4 digits are recommended) in the
9
first six boxes from left to right for each user code. Valid entries are: 0-9. Note: Press
a zero. No blank spaces in between; leave blank (•) any trailing boxes. If an "Ambush Pre-
fix" (Address 0495) is entered, do not program the first two digits of ANY User Code as the same
digits entered for the "Ambush Prefix".
If the programmed code is less than 6 digits, press
Refer to the tables on the next page for the available User Option data entries.
u
for a zero. Press
to save. Press NEXT ("r" or
through
1
for letters B–F, respectively. NOTE: Pre-Dial Delay = "D"; Dial-
G5
will produce a blank space (•). Press
0
) to proceed. NOTE: Central Station Receiver 2 and 3 Telephone Numbers can
button for a zero and press the
0
p
button for a zero and press
0
for letters B–E, respectively. Press
G4
DATA ENTRY
CS RECEIVER 1 FORMAT
9
FBI 4/3/1
0
Radionics Modem 2
B
SIA
C
Ademco Point ID
D
Ademco Express
E
Pager
) button to set cursor)
w
p
for digits 1–9; press
9
1
buttons for a blank space (•).
G0
) to proceed. NOTE: Central Station Receiver 2 and 3
G0
u
to save. Press NEXT ("r" or
NOTE: Modem IIe is available only
in Direct Address Programming.
Central Station Receiver 2 and 3
Formats can only be entered in
Direct Address Programming. See
CS Receiver Options.
to set the cursor to USER OPTIONS.
w
through
1
9
) to proceed.
for a zero
G0
u
to save. Press
through
for digits 1–
9
through
1
for a blank space (•). Press
through
1
for
0
11
.
Advertisement
