Chapter 3. Programming; Reset Master Code; Change Unit Master Code - PACH & COMPANY AeGIS 4000 Installation And Programming Manual

CHAPTER 3. PROGRAMMING

CHAPTER 3. PROGRAMMING
The AeGIS 4000 can be programmed Local (using built-in keypad), Premise Phone or Remote Phone. Premise phone
programming can only be used if the existing Central Office Line is connected to the system as shown in figure 2.1.
Keys Local Programming
Press this key once to exit from the
programming mode, you may need to
*
press the key twice to exit if you
already in the select function mode
Press this key
• once to accept program.
#
These keys is used to Reset the
Master Code to factory default.
Step 1
power switch to OFF, see
* and #
figure 2.1 to locate the power switch.
RESET MASTER
Step 2
CODE
simultaneously and turn the system's
power "On" (switch to the left). You will
hear "Two Short
"Three Short Beeps" then release the
∗ and #. Your master code is now
0000.
Function Local Programming
The default system Master Code
(0000) must be changed for security
purposes. The Master Code is always
4-digit long.
Step 1
Mode: Press 0 and # simultaneously
then release. If you are in the
00
programming mode, proceed to step 2.
CHANGE UNIT
Step 2
MASTER CODE
Code (factory default is 0000) and you
will hear "One Short Beep". If you
entered an invalid master code you will
hear "One
step 1. Should your master code
become lost or forgotten see Reset
Master Code.
Pach and Company
AeGIS 4000
Open the panel and turn the
Press and hold ∗ and # key
Beeps" then
Entering The Programming
Enter the 4-digit Master
Long
Beep", repeat
Premise Phone
Press this key
• Twice to initiate the call to the
AeGIS 4000, see function code
98 (must be selected to use * ).
• Twice to disconnect the call with
the AeGIS 4000.
Press this key
• Twice to initiate the call to the
AeGIS 4000, see function code
98 (must be selected to use #).
• Once to Extend the talk time for
another cycle.
• Once to accept program.
Premise Phone
Master Code cannot be replaced using
the premise phone.
Page 8
Chapter 3. Programming
Remote Phone
Press this key twice to disconnect the
call with the AeGIS 4000.
Press this key once to accept
program.
Remote Phone
Master Code cannot be replaced using
the remote phone.