Viewing The Test Log; Diagnostic Error Message Tables - IBM IntelliStation M Pro User Manual

Viewing the test log

The test log records data about system failures and other pertinent information.
The test log will not contain any information until after the diagnostic program has
run.
Note: If you already are running the diagnostic program, begin with step 4.
Do the following to view the test log:
1. Insert the Enhanced Diagnostics diskette or the Device Drivers and IBM Enhanced
2. If the computer is on, shut down your operating system and restart the
3. If a user password is set, the system prompts you for it. Type in the correct
4. Run the appropriate diagnostics program and when the Diagnostic Programs
5. Select View Test Log from the list that appears; then follow the instructions on
6. You can save the test log to a file on a diskette or to your hard disk drive.
Note: The system maintains the test-log data while the system is turned on. When

Diagnostic error message tables

The following tables provide descriptions of the error messages that might be
listed in the test log after you run the diagnostic programs.
Code Function
001 Core system
005 Video port
011 Serial port
014 Parallel port
Diagnostics CD.
computer.
password; then, press Enter.
screen appears, select Utility.
the screen.
you turn off the power to the computer, the test log is cleared.
Important
If diagnostic error messages are displayed that are not listed in the following
tables, make sure that your system has the latest levels of BIOS and
diagnostics installed.
Result Text message
Failed Processor board, ECC Test
System board
Processor and system boards
Integrated serial port
Integrated parallel port
Action
Call for service.
Chapter 6. Solving problems
55