Install The Door Speakers; Installation - Harman Kardon MaestroKitchen 100 Installation Manual

Install the Door Speakers

Completed Installation
1. Run the amplifier speaker wire from the door speaker cabinet to the head-unit mounting
location. IMPORTANT: Make sure the end of the wire with the connectors is in the
cabinet and the end of the wire with the tinned bare leads is at the head unit. Pull
enough wire into the cabinet to stretch all the way to the cabinet's front edge and tape the
wire at the hole so it doesn't fall back behind the cabinet. NOTE: You may also need to drill a
hole for the wires in the kitchen directly behind the head-unit mounting location.
4
2. Mark an "X" at the location inside the cabinet door recess at the indicated position. Make
sure the area around the "X" is free of dust or other debris.
3. Make sure the exciter' s inner mounting ring is screwed tightly to the exciter. Remove the
adhesive backing and attach the exciter to the door, centered at the mark you made in Step 2,
with the wire connection facing the bottom of the door. Press firmly on the exciter' s three screws
to assure that it adheres well to the door.
Drill hole for wire.
Tighten
ring.
Amplifier
speaker wire.
End of wire with
connections.
Remove backing

Installation

Place a
150mm
mark at the
indicated
position.
125mm
Attach
exciter
centered
on mark.
Wire
facing down