Hardware Mounting Installation; Free-Standing; Wall-Mounted - ZyXEL Communications ZyAir B-1000 Quick Installation Manual

Hardware Mounting Installation

Free-standing

Place your ZyAIR on a flat, level surface (on a desk or shelf) that is sturdy enough to
support the weight of the ZyAIR with connection cables.

Wall-mounted

Follow the steps to attach your ZyAIR to a wall.
Step 1. Locate a high position on the wall free of obstructions.
Step 2.
Secure two screws in the wall 60 mm apart. Do not screw the screws all
the way to the wall. Leave a small gap between the head of the screw and
the wall.
Failure to use the proper screws may damage the
Make sure the screws are securely fixed to the
wall and that the wall is sturdy enough to hold the
weight of the ZyAIR with the connection cables.
Step 3. Refer to the Hardware Connections section. Connect the cables to the
ports on the ZyAIR.
Step 4.
Adjust the cables.
a. Run the connection cables down the back of the ZyAIR as shown in
the following figure.
Diagram 2 Run the Cables Down the Back of the ZyAIR
OR:
ZyAIR B-1000 Wireless LAN Access Point
unit.
5