Table of Contents
Advertisement
Installation in the vehicle | Switching on/off | Reset
Attaching the cradle
The suction cup holder features a mount for the
cradle.
u
Snap the cradle with the suction cup holder
into position.
Installing Lucca in the cradle
The Lucca features an opening on the underside
for mounting the cradle.
u
Remove the elastic cover from the underside
of the housing.
u
Place the Lucca on the mount of the cradle
and snap the Lucca to the rear and into posi-
tion.
Removing the Lucca
u
Press the lever of the cradle at the rear side of
the Lucca and pull the Lucca to the front.
u
Remove the Lucca to the top and out of the
cradle.
To protect the contacts, you can use the elas-
tic cover and dummy card again after using the
Lucca.
10
Switching on/off
Initial switch-on
During the initial switch-on of the Lucca, the soft-
ware is loaded into the system. For this reason,
the switch-on process
The initial destination guidance also requires a
longer time than usual.
Switch-on
u
To switch on the Lucca, press the On/Off
switch below the display.
The Lucca is switched on. (If the device is in
the idle state, the previously active display is
shown again.)
Activating the idle state
u
To activate the idle state, briefl y press the On/
Off switch below the display.
The Lucca switches to the idle state.
Switching off
u
Press and hold the On/Off switch for longer
than 3 seconds to switch off the device.
The Lucca is switched off.
Note:
A complete switch-off of the Lucca is only nec-
essary if you do not operate the device for an
extended period of time or if you want to load
new map material from the SD/MMC card.
Reset
The Lucca can be restarted by using the Reset
button.
u
For this purpose, press the Reset button on
the underside of the Lucca.
may last up to one minute.
Advertisement
Table of Contents
