Table of Contents
Advertisement
6
EN
Connections
Antenna or Cable
Flat Feeder
AC Power
Matching Transformer
Cord
(Not supplied)
Back of VCR
AC
Outlet
Audio/Video
Cable (supplied)
TV
NOTES:
The VCR channel is the channel on the TV which will display
the audio and video signals from the VCR. The VCR's CH3-
CH4 switch, on the back of the VCR, sets the VCR channel to
CH3 or CH4.
The CH3–CH4 switch is preset to the CH3 position.
Set to CH4 if CH3 is used for broadcasting in your area and
set the channel on the TV to correspond to the VCR's CH3–
CH4 switch setting.
If RF connection to TV is used, when switching from VIDEO to TV
mode and from TV to VIDEO it may be necessary to issue a CH
UP and then CH DOWN on TV to obtain a good quality picture.
Even if you are using AV cables to connect your VCR to your TV,
you must also connect it using the RF cable. This will ensure that
you can record one show while watching another (
For full identification of the VCR's rear panel, refer to the
Index (REAR VIEW
Coaxial Cable
RF Cable
(supplied)
75 ohm terminal
Back of VCR
CH3
CH4
pg. 71).
INSTALLING YOUR NEW VCR
Basic Connections
CHECK CONTENTS
1
Make sure the package contains all of the accessories
listed in "SPECIFICATIONS" (
SITUATE VCR
2
Place the VCR on a stable, horizontal surface.
ANTENNA-
IN (Antenna
CONNECT VCR TO TV
or Cable
input)
3
The connection method you use depends on the type of
TV you have.
RF Connection
TV OUT
AV Connection
S-VIDEO Connection
CONNECT VCR TO
POWER SOURCE
4
Connect the power plug to an AC outlet.
FINAL PREPARATION FOR
USE
5
Power on the VCR and select the VCR channel (3 or 4)
by setting the switch on the rear of the VCR as shown in
the illustration.
You can now perform simple playback (
simple recording (
pg. 41).
To Connect To A TV With NO AV Input Terminals . . .
a– Disconnect the TV antenna from the TV.
b– Connect the TV antenna cable to the ANTENNA
IN jack on the rear of the VCR.
c– Connect the supplied RF cable between the TV OUT
jack on the rear of the VCR and the TV's antenna
terminal. Set TV on CH3 or CH4 corresponding to the
CH3 – CH4 switch setting on the back of the VCR.
To Connect To A TV With AV Input Terminals . . .
a– Connect the antenna, VCR and TV as shown in
the illustration.
b– Connect an Audio/Video Cable between the
AUDIO OUT and VIDEO OUT jacks on the rear of
the VCR and the AV IN jacks on the TV. Set your
TV in video input mode or A/V input mode. Refer
to the TV Instruction Manual.
If you have a TV with S-VIDEO input terminals, see
"S-VIDEO Connection" on page 7.
The clock will automatically be set when the antenna
is connected and when the AC is first connected to
the VCR (
pg. 8).
(If "Auto" is displayed on the front display panel
before the VCR is powered on, the clock is being set
automatically. Wait for the time to be displayed on
the front display panel before powering on the VCR.)
pg. 27).
pg. 73).
pg. 26) or
Advertisement
Table of Contents
