Table of Contents
Advertisement
Connections
Make sure that the power to the video cassette player and TV
is off before making the following connections.
HR-JP400K
HR-JP200A
Connection A (basic)
In order to use the video cassette player it must be connected
between the antenna and the TV.
Connect your TV antenna cable to the video cassette
1
player's ANT. IN terminal.
Connect one end of the provided RF antenna cable to
2
the video cassette player's RF. OUT terminal and the
other end to the TV's antenna terminal.
Connect the power cord to your household AC outlet.
3
Connection B
For connection of a TV that has VIDEO/AUDIO IN/OUT termi-
nals. This connection is necessary to record TV programmes.
Use RCA type pin connection cords (available from audio/video
stores) for connection. This connection is in addition to connec-
tion A.
Follow steps 1 and 2 of "Connection A".
1
Downloaded from:
https://www.usersmanualguide.com/
Connection A
Connection B
Connection A
Connection B
Note:
If you put a TV set directly on this VCP or install it too close to
a TV set, noise may occur. If this noise occurs, separate the
VCP and the TV set.
2
Connect the TV's VIDEO OUT and AUDIO OUT termi-
nals to the video cassette player's VIDEO IN and AU-
DIO IN terminals.
3
Connect the TV's VIDEO IN and AUDIO IN terminals to
the VCP's VIDEO OUT and AUDIO OUT terminals.
4
Connect the power cord to your household AC outlet.
TV system
The TV system switch should be set as follows.
K position: Set to this position for K system areas (East-
G position: Set to this position for G system areas (West-
Note:
• When connection B is used to connect the TV and video
cassette player, setting the TV system switch is not
necessary.
32(24)
40(27)
K
G
002
RF OUT
32(24)
40(27)
K
ANT.IN
G
002
ern European countries).
ern European countries for example).
K
G
RF OUT
IN
OUT
AUDIO
ANT.IN
VIDEO
STANDBY/ON
VIDEO
AUDIO
OUT
AUDIO
VIDEO
5
Advertisement
Table of Contents
