Replacing The Palm Rest - Dell Studio 1735 Service Manual

Hide thumbs Also See for Studio 1735:

Quick setup (2 pages)

Setting up your computer (2 pages)

User manual (354 pages)

Table Of Contents

Table of Contents

5 speaker cable connector

NOTICE:

Pull on the plastic tab on top of the connectors to avoid damaging the connectors.

7. Disconnect the speaker cable connector, touch pad cable connector, media control buttons cable connector, and the optional fingerprint reader cable

connector from the system board.

8. Starting at the back center of the palm rest, use your fingers to gently ease the palm rest from the computer base by lifting the inside of the palm rest

while pulling on the outside.

NOTICE:

Carefully separate the palm rest from the computer base to avoid damage to the palm rest.

Replacing the Palm Rest

1. Align the palm rest with the computer base and gently snap the palm rest into place.

2. Connect the speaker cable, touch pad cable, media control buttons cable, and the optional fingerprint reader cable to the respective system board

connectors.

3. Replace the four screws on the top of the palm rest.

4. Turn the computer upside down and replace the eight screws in the computer base.

5. Follow the instructions in

Replacing the Display

6. Reinstall the memory modules and Mini-Cards, if any.