Chapter 2: Board Installation; Board Image - TYAN Thunder K8SR User Manual

Chapter 2: Board Installation

Precaution: The Thunder K8SR supports EPS12V/SSI type power supplies
(24pin + 8pin) and will not operate with any other types. For proper power
supply installation procedures see page 26.
DO NOT USE ATX 2.x or ATXGES power supplies as they will damage the
board and void your warranty.
How to install our products right... the first time
The first thing you should do is read this user's manual. It contains important
information that will make configuration and setup much easier. Here are some
precautions you should take when installing your motherboard:
(1) Ground yourself properly before removing your motherboard from
the antistatic bag. Unplug the power from your computer power
supply and then touch a safely grounded object to release static
charge (i.e. power supply case). For the safest conditions, TYAN
recommends wearing a static safety wrist strap.
(2) Hold the motherboard by its edges and do not touch the bottom of
the board, or flex the board in any way.
(3) Avoid touching the motherboard components, IC chips, connectors,
memory modules, and leads.
(4) Place the motherboard on a grounded antistatic surface or on the
antistatic bag that the board was shipped in.
(5) Inspect the board for damage.
The following pages include details on how to install your motherboard into
your chassis, as well as installing the processor, memory, disk drives and
cables.
DO NOT APPLY POWER TO THE BOARD IF IT HAS BEEN
NOTE
7
WWW.TYAN.COM
DAMAGED
2.00 – Board Image
This picture is representative of the latest board revision available at the
time of publishing. The board you receive may or may not look exactly
like the above picture.
The following page includes details on the vital components of this
motherboard.
8
WWW.TYAN.COM