Setting Up - Geemarc ClearSound MyDECT 100 User Manual

Now available to purchase from www.M2Cshop.com

Setting Up

Plug the power cable into the power socket on the base. Plug
the adaptor end of the power cable into the mains supply and
switch the supply on. (*)
Connect the line cord plug to the line socket on the base.
Connect the other end of the line cord to the PTT socket. (**)
Install the rechargeable batteries in the handset. The handset
requires two Nickel Metal Hydride (NiMH) AAA batteries. These
are supplied with your telephone. Slide the battery cover in the
direction of the arrow and pull it out. Check the battery polarity
diagrams on the handset when inserting the batteries. Fit the
battery cover by sliding the cover on to the back of the handset
until it snaps shut.
Place the handset on the base, a short beep will be heard. The
battery symbol
handset is fully charged, the display will show a full battery symbol.
The telephone has an automatic charging control to avoid
excessive charging.
Before the handset can be used, the handset batteries must be
charged for a minimum of 15 hours on the MyDECT100TM base
(*) Classified "hazardous voltage" according to EN60950 standard
(**) Classified TNV-3 according to EN60950 standard.
Now available to purchase from www.M2Cshop.com
INSTALLATION
will be displayed on the handset. Once the
15
.